|
Untitled Page
ARCHIVED FORUM -- April 2007 to March 2012 READ ONLY FORUM
This is the first Archived Forum which was active between 17th April 2007 and
1st March February 2012
Search
-
Hello I don't think it is a mission impossible, the tape deck commands could be interfaced to the IPOD using solid state relays (like Omron or similar). There could be a lot of work to do but not difficult; for example you have to simulate the paly feedback to avoid the disabling of the unit.
-
Hello I'm trying to find the problem in the remote receiver module of a Beocenter 7002 but no good results obtained; I have another module that works best, so I started to change from the not working card to the working ones the IC (IC1 and IC2) and after the transistor but all components are good and the card still working and the other one not
-
Inside the red circles (circles...) there are the two eccentric used to set the starting point. Normally I use to set them from above the turntable, here is the procedure... sorry but my scanner is broken and I need to fix.... ciao ciao
-
As soon as is possible I'll put here some photos ciao ciao
-
Thanks a lot, so the unit is working perfectly! I'm very happy ! Just another little question, I dismounted the cover because there are some scratches to remove and three little pieces of chromed metal appeared ... Do you know where they was placed? Have a good day
-
Hello I'm using a Beogram 1700 but a can't understand how to stop the LP reproduction and park the stylus using the turntable control panel . Could someone help me? bye Eugenio
-
Next is to check if tension is present on the motor, if you have a tester you can check this after this check we can understand the problem origin. I think Martin can have the motor as spare. I'll be offline from today to the 25 of this month so if I don't reply don't worry ok? ciao ciao and best August 15
-
Hello I found on sale in a local store the couple, male and female dot-line connector, if you need let me know, if I remember right they cost 1,50 euros a couple ( a packet). If you need let me know ciao ciao
-
Hello Sam When you set the play command motor start and the system wait for the "running" feedback, try to remove the belt and check if the motor start before the solenoid are DEACTIVATED (powered off). If the motor doesn't start there could be a problem inside it or on the Tape deck PCB, let us know ciao ciao
-
|
|
|