in Search
Untitled Page

ARCHIVED FORUM -- April 2007 to March 2012

This is the first Archived Forum which was active between 17th April 2007 and 1st March February 2012


Latest post 10-01-2008 5:48 AM by MatthewWilde. 2 replies.
Page 1 of 1 (3 items)
Sort Posts: Previous Next
  • 09-30-2008 6:55 AM

    Century - handle screw dimensions?

    Hello.  The Century comes with a detachable handle-***-aerial, held in place by two screws.  I detached mine years ago, and now want to replace it.  I'm not certain if I have the right screws!  The two I've found are black, flat-ended and measure 27.0 mm x 2.5 mm.  Can someone confirm that these are the correct ones?  Thank you.  (I promise to sellotape them to the handle, if I remove them again!)


  • 09-30-2008 8:53 AM In reply to

    Re: Century - handle screw dimensions?

    Hi Matthew,

    the dimensions you give are broadly right (27.27mm x 2.78mm).  Here is a picture of one of the scres.  The head is slightly domed, with a single slot for screwdriver but will also take a 10mm hex driver.  In the middle of my heads there is a brass coloured centre with a small hole drilled in it (part of the machining I'm guessing.



    Am I ready? I was born ready!

  • 10-01-2008 5:48 AM In reply to

    Re: Century - handle screw dimensions?

    Many thanks, Dave, for a very helpful answer.  Problem solved!


Page 1 of 1 (3 items)