Untitled Page
ARCHIVED FORUM -- April 2007 to March 2012
READ ONLY FORUM
This is the first Archived Forum which was active between 17th April 2007 and
1st March February 2012
Search
-
ok, tried the above - no good - refresh me on how to access service menu please! Also, I have a pc connected to the 32 which is working in dvi-i even with it disconnected can't get the 32 to work having reset/programmed the conns etc
-
+1 Just about to post a question in similar vein - tried both hdmi -> dvi cable and also a red/blue/green _>4 pole jack no result as above guidance please tony
-
got one spare, where are you? pm me tony
-
yep tighter bends etc - as you bend fatigue(work hardening) occurs with possible crystalisation fracture, at thet point repeat the heat treatment and off you go again until hardening occurs - same with copper etc(tomatoe/cherry red) Used the process on class m(marblehead) model yacht booms etc slightly more difficult with tube, need to fill and seal
-
Tip for bending ali, put a coating of soft soap(any bathroom type) on the area to be bent/shaped then use a blow torch gently on the area - when the soap blackens stop heating allow to cool and bend when /if it work harden repeat the annealing process - finally burnish it to the reqd finish. Used to work in the Technology Dept in a school, had to produce
-
better a noisless hum, then the skys the limit! tony
-
unchain my heart etc Joe Cocker the ultimate collection disc 1 bc 9300/bl5000
-
Was there not a thread a couple of years ago re pcb changes to achieve this?
-
don't think so mine does the same however not tried another source as yet!!
-
replace the converter with an active, that works and you have the eye to control the speakers tony