Untitled Page
ARCHIVED FORUM -- April 2007 to March 2012
READ ONLY FORUM
This is the first Archived Forum which was active between 17th April 2007 and
1st March February 2012
Search
-
Glad to hear that it works! Have you had time to test anything yet? How is the response, both when say changing a chanel on a TV and turning on/off lights? Is it direct or is there a delay? /Lars
-
Hi Anders! I don't have MLGW yet, but I'm thinking about getting one as I also have a LK IHC system in my home. From what I have read you need to patch the IHC controller in order to get it to work. Have this been done? Below is what I found in the installtion guide ( http://mlgw.bang-olufsen.dk/source/documents/mlgw_1.70a/MLGW%20Installation
-
I use LK IHC system to control my somfy powered blinds. It works fine and there is B&O ir recievers so that I can control the blinds with beo4. However I think the somfy motors makes to much noice, anybody else that has noticed this? Are there any other motors recommended?
-
Has anyone compared the above speakers to be used mainly as TV stereo speakers? Is there a big difference soundwise?
-
Has anyone tried a Velodyne MiniVee SPL-800i? Will it work in a small room with Beolab 4000 as fronts (both for music and movies)?
-
Hi, I have a Beosystem 1 EU in the main room and I want to distribute the sources connected to it to other rooms. But when I connect the incoming RF signal to it and then the other rooms to the outgoing link on the Beosystem I get no signal (not even the incomming signal) in the other rooms if the Beosystem is turned off. Should it be like that? If
-
Hi, I have a type 8810 with software version 16.3. I also have a STB contoller (I dont't know if this matter). You can find the software version by pressing menu->setup->00 GO->monitor
-
On my BV3-32 I can assign STB (and also PC) on the connection menu, so it will start by pressing the SAT button on the Beo4. I think it's related to the software version.
-
Hi, I'm also planning to use a MCL2P to drive a center speaker. Not delighted to hear that it sounds to low. Could this be dependent of the speakers? That the once you have requires more power but that other speaker would be fine with the MCL2P? Is it possible to bridge a MCL2P so that you will get more power on the mono channel?
-
No one with some information regarding mlgw v3?