Blacktrix Can you tell me how i activate a new four digit pincode now i have entered the master code? Kindly Regards Thomas

Thank you Blackrix ! It worked! Happy holidays to you!

Hello out there Bought a second hand MX8000 and had it stored for a while. i forgot the code and contacted b&o, they gave me a five digit code, and told me to follow the user guide. The user guide says that i have to look at the CD ROM, which i dont have. Do any of you know what i should do with the 5 digit code, when the tv only asks for 4 ? Kindly

Hi Blackrix Do you know where i can find a servicemanual for the AV5 to check? Thomas

Hello out there To make a long story short.. i have a BeoCenter 3000 with a faulty cd mechanism. It seems like the servo IC's are making a lot of trouble. I have used a lot of time on troubleshooting it. I have a hard time finding a cd mechanism for it, and i was wondering if a mechanism from a Beocenter AV5 can be transfered to the Beocenter 3000

Well I have done some control measurements. Controlling the supply voltages for the circuits on the CD Pro2 board. They seems okay. I returned to the issue, that the spindle motor did not rotate, even that it got the service command "TM 63", if i rotate the cd with the fingers, im able to hear some acoustic noise. I can se a wierd triangular

Hello guys After further investigation, im a bit confused. I can not find the resistor to measure the laser current 80R3121. I have tried to operate the unit in service mode. When i try to play cd, it plays nice with sound for some time and give me "Error 37" : The manual says "Selection error" with no further explanation. Sometimes

Hello out there My lovely beosound 3000 have started doing trouble... When i try to load a cd, the clamp goes down, and opens a few seconds after. The cd does not spin. Sometimes it turns ~1mm. Sometimes it suddenly reads the cd, and plays... it can play for like half an hour, but then suddenly stop... I have just buyed the service manual. http://dl

yachadm, Die_bogener, Dillen ... >> Maybee i wasnt clear in my post, sorry guys! I read a lot of your replies at this workbench forum, i know you all are experienced, and you should know i really admire you are doing repair on component level, and i totally agree about upgrading to better spec capacitors. I just wanted to share my experience with

[quote user="Clive"] The cd doesn't spin after accepting a disk and the door then reopens. I've tried a very light clean of the laser lens to no avail. Are there any common faults or simple checks I could do with a meter for example before admitting defeat and taking it to the local store for a mechanism change out? 9300 is a type