Hi.  On the Beovision 2802, the Beolink 1000 remote does not work.  So I bought a copy remote that was guaranteed to work with the TV without any setting up - but that does not work either!  Do you think the TV has a problem with its IR signal?

Can you turn it on manually on the telly?

Yes, I can.  I can switch it on with those little buttons at the bottom of the screen.

Sounds like an IR problem but before calling the service department, with the set in stand by, press:

PICTURE 1 STORE

on the Beolink 1000 and then see if it works.

Thanks, Peter. Will try it tomorrow, and let you know.  Best wishes, Julie.

Welcome to the forum Julie!

Andy T.

Thanks.  I think the Beolink is definitely dead - nothing works. I bought a copy remote, which  works the basic functions (like on/off, volume, etc), but I can't seem to change things like brightness/contrast, or get teletext, or any kind of set-up menu.  Can you help?   Julie.

 

This reminds me of getting my LX5500.

I could not get the Beolink 1000 to work at all. I checked the batteries which were all fully loaded. The B&O dealer is only a 5-10 minutes walk so I went and got it fixed. He installed a new print board and it has been working ever since.

 

You can also try something else. I got a Video Terminal before my Beolink 1000 for use with my L2800.

The seller demonstrated the Beovision with a Beolink 1000 but gave me the V -Terminal to use.

It needed batteries but it did not work either. I took it apart and tried to touch the printboard. That worked. Put it back together and it worked with no problem. Got a new rubberpad as it had several numbers ripped from use.

Be carefull when open the remote as there is 2 wires going to the batteries. If they get loose you need to solder them back on.