Hi,

Is there a trigger to detect the BV9 is turned on?
I want to connect it to a domitic system.
A switched output is ok, whatever voltage 
Is the  "DTV Data" connection on the BS3 sending data ?
I can do it by measuring the used power, but a direct connected status should be easier ...

nico

I guess you could test the power on one of the SCART socket.

The official way to integrate a Home automation system and B&O is the MLGW box.

Expensive, but you'll get 2 way communication:

The home automation system knows the status of each TV, and you can send commands to your home automation system with the Beo5 or the new Beo4.

thanks ! , but i found another way to detect it.

pin 1 of the powerlink connector for the center speaker will go to 2,5 V when the TV is on.
This way i can detect only when the TV is on and not when the radio is on because this speaker is only used in a TV setup.

nico