Hello all, I am new to this forum though a long time B&O owner. I am wiring a new home and have an old (1996ish) BeoCenter 9300 and a BeoLab 3500 that I want to connect. They will be in separate rooms a good 150 ft. apart. I had a 75' MCL cable from the original install, so I asked my local B&O dealer what I needed to get the two connected and after humming and hawing a bit they finally sold me 150' of expensive thin white cable. I didn't look closely at it at the time, because my 75' run was still in the wall, but now that I have extracted my original MCL cable (circa 1998) the two cables are dramatically different. So I looked on this web site and found that the cable they sold me doesn't seem to conform to either the Masterlink wiring or the Master Control Link wiring standard. It has only 5 wires in the jacket, light grey or possibly light blue, green, brown, white and yellow. Can anyone tell me whether this wire will in fact work, and if so how do I wire it to a master link junction, or masterlink wall plate, both of which seem to want 9 wires. Any help appreciated.