hi looking for some advise?

i have a beocenter 9500 (which i am selling) connected to an mcl xtra speaker kit for my bathroom (built in ceiling speakers) but i have just bought a beosystem 2500 and need a bit of advise on how to connect the two 3 pin mcl plugs to the 2500?

am i correct in thinking i need an mcl2p? and is there anything else i require?

cheers guys

mark

That should be all - and the cables to connect it of course!

thanks peter.

so am i right in thinking that the amp will go downstairs near the 2500 and the 3 pin plugs just go into it and then one powerlink (fully wired 8 pin) goes from the 2500 to the amp? (i have one spare as it running a pair of pentas).

mark

That is it!

Hi all would i be ok using an ml/mcl converter in place of the mcl2p?

cheers

mark

Yes, it is essentially the same thing. 

Update, i have just bought a beolink passive for my above setup but when reading the manual it says not to use the powerlink socket, so have i wasted my money or is there a way around this??

thanks

mark