Hello and scuse me for my bad english....

Can someone explain me what the 'function_' command is?

I have tried to use it with a Lintronic in order to convert this command into a command to control an external  set top box, but it seems to freeze.....

What is the correct use for the 'function_' command?

As far as I am aware the "Functions" have only been used with Lintronics to date and are intended for 3rd party control.

The Lintronic relay card is a good example and teh following are the "Control" and "Function" commands

CONTROL COMMANDS
Control 0 = All relays
Control 1 = Relay 1
Control 2 = Relay 2
Control 3 = Relay 3
Control 4 = Relay 4
Control 5 = Relay 5
Control 6 = Relay 6
Control 7 = Relay 7
Control 8 = Relay 8

FUNCTION COMMANDS
Function 1 = On for 1 second
Function 2 = On for 2 seconds
...
Function 30 = On for 30 seconds
Function 31 = On constantly
Function 32 = Off constantly
Function 33 = Toggle On/Off
Function 34 = Reserved
Function 35 = Reserved
Function 36 = Reserved
Function 37 = Toggle "Input 1"
Function 38 = Toggle "Input 2"

These are used with the "Light" command

In addition to that Beo uses CNTL commands for PUC control via Beo5. For example if "GUIDE" is controled by MENU - 2 via Beo4 and GO - 2 from linkrooms it`s CNTL-2 via Beo5. The same for CNTL-0 - CNTL-9.

Stefan