I have recently bought a Beogram 1700 to run through my Beomaster 1500 amp/receiver. Annoyingly the people I bought the Beogram from had cut off the B&O 5 pin din plug and replaced it with red and black phono jacks (obviously to run it through a newer system). I want to re-wire this to run it through my Beomaster. I am normally pretty good with wiring but this has me confused. Which wire go to which pins? I have searched online but there either isn't a diagram anywhere or I am looking in the wrong places! I would be very grateful of any help anyone can provide.

Sam.

Beotech is the technical part of this site. However I think this is what you need. Remember the earth to the shell of the Din plug.

Thanks for getting back to me Peter. Is there a larger picture of this diagram? I tried to enlarge but it just blurred on me. Thank you so much again. I can't wait to get this running.

Sorry about that! Scanned it too quickly - busy doing the Beocenter 4000 manual! This should be better!

Fantastic, cheers Peter. Will get the soldering iron out tomorrow!

Sam