My DVD1 is no longer responding to commands via my LX5500. I does work fine using the buttons on the front of the DVD player. I checked the scart leads and found no problems. I use an AVX1 expander and there is no problem with that. I use CDV for the DVD1 but have also tried VTape2 and all scart sockets and nothing happens. Any suggestions?

David

remote setting?

you use a beo4, no?

I have BL1000 and Beo4 so no remote problems.

Thanks

David

hmmm...

have you made any recent changes, as in re-cabling?

i think that is good practice, if b&o doesn't already state this...

to make all your connections prior to powering up.

i would suggest trying:

1.) power both devices down

2.) recheck connections

3.) power back up after 1+minutes.

4.) confirm on-screen setup.

let us know...

Reconnect the scart cable. Commands are sent through pin number 8, so if it is disconnected, it can cause this problem.

I tried the DVD1 directly into AV2 of the LX and it works fine so there is a problem with the AVX1 not transmitting the pin 8 signal. It must be a dodgey scart plug connection no doubt caused by everyday use of the motorised stand.

Thanks for the help all

David