Hello, Can anyone tell me how to wire a new din plug to the cable of my Beogram 1000 record player?

The original has been cut off and i dont know which wire goes to which pin in the new plug.

Thanks

Near-impossible for me to describe properly without a diagram. If this Beogram is new to you the service manual downloadable here is well worth it because it shows how to set up the tonearm properly and everything else - including the circuit diagram that'll answer your question.

I find that soldering a DIN plug is fraught with hassle because the plastic that hold the pins tends to soften under heat and the pins end up skewed - plugging it into a socket before I begin is the workaround I use for my poor soldering technique. I had the same problem as you with my Beogram, and I found it a lot easier to replace the entire lead with a ready-made extension cable from Maplin - I cut off the line socket and stripped the wire ends and soldered them into the Beogram.

Cheers, Steve
 

Thanks for that Steve, sounds like the best option as my soldering skills are not up to much.

Thanks  Phil