Untitled Page
ARCHIVED FORUM -- April 2007 to March 2012
READ ONLY FORUM
This is the first Archived Forum which was active between 17th April 2007 and
1st March February 2012
Search
Page 1 of 1 (9 items)
-
Marc, remove the plastic trim just above and below the screen (use a small screwdriver to prise it away at the sides of the set). Then undo the four philips screws and remove the contrast screen takeing care that it doesnt fall forwards. Good Luck
-
Try cleaning the i.r. prisms (2 clear plastic bits under the glass), the aluminium and the glass inside & out. If they get dirty they can cause some very strange problems. Good Luck
-
Just put your finger through the fabric hook the frame and pull
-
It was a 5 room ML setup, all was well but then had various strange probs. System would go into standby, only radio available in link rooms etc. Tested ML with b&o tester- all ok then told to try earthing. It turned out to be a fault on the vision 7 motor stand which was swapped. But have since been advised that all ML networks should be earthed
-
Keith, b&o technical Regards Simon
-
Thanks Keith for the reply, they are saying all ML cables should be earthed ( even just between two products). If this has to be a "clean" earth presumably it will require a seperate earth rod etc. which will add expense and may be impossible in some situations ie. flats etc. Regards Simon
-
I have recently been informed that all ml installations should be earthed. I spoke to an electrician who reckons as it is a low voltage cable it should not be earthed to comply with regulations. Does anyone know if this is the case and if it isnt how it should be earthed ( from the nearest socket , from consumer unit or other?) Thanks
-
Yes it needs an internal nicad replacing
-
You can use hdmi to hdmi ( 10m max) with adapters. Have done 10plus with no problems. Good Luck
Page 1 of 1 (9 items)