|
Untitled Page
ARCHIVED FORUM -- April 2007 to March 2012 READ ONLY FORUM
This is the first Archived Forum which was active between 17th April 2007 and
1st March February 2012
Search
-
Hi Ducha Great news and well done, you have now got enough gear to keep you busy for the next two years!!! I got a similar setup about three weeks ago and I have slowly been working my way through it all. So far, the beogram and the beocord have now been returned to full working order and I have refoamed a set of M150.2 speakers. They now sound great
-
Hi Chris Never give up, all it takes is lots of time!! I have checked the voltage on the motor when it is going to the start position and it seems to be between 8 and 9volts. Looks as if your motor is doing its job. So if you are happy that the initial park position is OK and the motor is able to reach the correct speed, it might be time to look at
-
Hi Friedmett I have been using Powerlink outputs to Beomaster Tape inputs for a long time now. My solution has worked successfully although I must admit that I don't really know how technically sound this connection is. Most important of all, it hasn't resulted in any damage that I am aware of and the quality of the sound is good. In my case
-
I can't believe that you have two machines which are both playing up to that extent!! Are you sure that the voltage supply to your house is not rediculously low for some funny reason. I have checked the stroke and the speed of the arm during the initial movement and come up with the following information which is the same on both my BG6006 and BG8002
-
Hi everyone I have recently put together the CX100 after refoaming the drivers and now I am confused. According to the manual the layout seems to be as follows and that is how I installed it: Top speaker 8480174 red and black wires Bottom speaker 8480173 orange and yellow wires Speaker has the hole in the back Martin seems to know that 73 goes in the
-
Hi Martin I had wondered about the belt slipping option but this did not appear to be an issue because the arm can be moved to any position using the manual button. If you get a small amount of slipping, what stops the motor doing a few extra revs to compensate? Does the motor continue driving until the opto sensor reaches the correct amount of revs
-
Hi Chris Thanks for the updated description of your problems, it gives me a better idea of what is going on. I have done a lot of work on my BG6006 and managed to get it working properly but there are plenty of things that I still have to learn about this machine. The first point that you have made is that when you press PLAY, the arm comes up short
-
The manual seems to indicate 140 and 2500Hz GR
-
Hi everyone Another BM8000 issue has come to light. I am able to program the memory with nine radio channels and the start up sound level, and all works well for a while. However, after a day or two, the unit starts to suffer from memory loss and all of the channels revert back to 87.5MHz. The start up volume usually comes in lower and eventually, after
-
Hi Chrisbou, Welcome to BeoWorld Would you please clarify the symptoms because I’m not sure whether I understand them correctly. If you press PLAY, does the arm not move at all If you press <<, presumably you can move the arm to the desired spot on the disc, so the left and right manual movement controls work OK. This means that the belt
|
|
|