|
Untitled Page
ARCHIVED FORUM -- April 2007 to March 2012 READ ONLY FORUM
This is the first Archived Forum which was active between 17th April 2007 and
1st March February 2012
Search
-
Do you want to exchange OP with tube, right? I think there is no enough space, maybe you have to build an external box. What do you need as help?
-
Hello I'm here to discuss about clock. I have a Beocenter 9300 that power on, open and close doors, but not enable the speaker output. The relay is ok, the problem is in the IC1 of the amplifier PCB, it doesn't receive the clock at pin 3 so I started to go backwards in the circuit to check where the clock disappear, in the Base of TR7 of PCB
-
Were are you from Maurice?
-
hehehe... hahaha... Martin once again! Thanks very very very much Martin, with your help I solved the problem, the fault was in the L2 coil, I exchanged the L2 and L3 position and found that the L2 is not good. Thanks again and again :) ciao ciao Eugenio
-
Stereo decoder exchanged with the other from the good pcb, no good results. exchanged IC decoder output channel L & R , same result. Tomorrow I'll try to exchange the trimmers that lower the FM out signal. I'll keep you informed Hope this helps ciao ciao
-
Hello This morning I start to play on a Beocenter 7002, all pcb are recapped including the radio section. I have a problem on this pcb (PC2 - the one under the turntable), the signal is good, the receptions are good, not disturbed and frequencies are discriminated perfectly. BUT... the sound is loud, one channel is better but each if compared with another
-
Hello I've had the same problem, on some units I removed the rubber ring and put into his groove just a bit of teflon tape and then remounted the rubber ring. Try to clear the other rubber weels and clean the 12135 metal axe. Put attention, don't fit too much teflon or you have to adjust the play speed due the different perifeal speed. If this
-
-
Ok we'll be here tomorrow to see the shot ciao ciao
-
Do you have a photo? ciao ciao
|
|
|