|
Untitled Page
ARCHIVED FORUM -- April 2007 to March 2012 READ ONLY FORUM
This is the first Archived Forum which was active between 17th April 2007 and
1st March February 2012
Search
-
just ordered my copy. can't wait to get it~ thanks in advance
-
thanks so much again. I have verified that my firmware is only 1.50. Is it possible to upgrade the firmware? I went to the local B&O store customer service (the only one here in Korea) and they said that it is not possible and even if it is, they cannot perform the operation. if it is available overseas, do you know how much roughly it might be
-
repost for those of you who haven't seen the vid on spotting fake A8's
-
this sounds very tempting... i'll be flying from Seoul to Brussels on the 1st of April and I guess I could stop by London for a few days. now if only i can convince my wife and daughter...
-
thanks for all your input Keith. i've read many of your posts and they saved me visits to the B&O after service store which, here in Seoul, is a big pain (and frankly not as informative as your posts).
-
yes, to reset, I did the same thing yesterday. except for int, I pressed hold
-
-
Ok, so i've managed to reset the phone (I think it was #9#9#*Hold). Now i've tried to register the phone to the base. the base was blinking and the phone said "searching base" but after about 5 mins nothing happened. isn't the base number supposed to show up on the phone? i'm so lost... any help please?
-
Thanks for your advice, Jandyt. FYI, I have read a number of your previous posts and they were helpful for other matters. I tried to deregister the beocom 2 but was unable to. Do I need to have the beoline that it was registered to on hand in order to deregister it? since i haven't been able to deregister it, i am not getting the prompt to register
-
I recently received a MKII Beocom 2 that was previously registered to a beoline system. I would like to register it now to my Beocom 6000 MKI master. I tried pairing them by pressing the button on the 6000 base and the light flashed red, then I put the Beocom 2 into register mode (by selecting advanced settings and then living room (name of phone) and
|
|
|