Not an expert and not familiar with the LinkConverter ( yet ) but as far as i know almost all ML products can put sound on to the ML but only from one component at a time since there is only one "soundbus" on the ML. Only one unit is allowed to supply power to databus on the ML and sense is used to detect this. Moritz

You get this error when there is no communication between TV and ControlCenter ( stand ). If the TV doesn't power up the problem is there.( Red led on top of TV should be on in st-by ) If TV powers up the problem can bee blocked MasterLink. Try a good ML-cable between TV and ControlCenter to check communication between them. If this helps then the

Hi There Just bought a used AV9000 and used many hours last week programming Crestron, testing + + +. I only use ir from Crestron, not the B&Oadapter. (learning a beo- remote takes time since there are a lot of different codes for every button) Analog TV-channels are soon gone here in Norway so i'm using sat ( non B&O ). Controling the receiver

Found the problem. ( partly... ) MasterLink sense pin4 has to bee high on the MPAV. I didn't get the original ML-cable so i'm using an other. Mabe use of the right cable would have solved the problem much earlier. Only problem now is that i have to use A/V button before selecting a source on the MPAV. Suggestions anyone? Not a big problem since

Thank you, "light" and "open" are the only operative functions on my unit too. In testmode i can operate the cd, tape and radio, the I2c bus seems ok and PSU voltages too. So far all seems ok but I don't have the servicemanual so i'm not 100% shure. With masterlink connected: Beovision 9000 sends info on the Masterlink when

New to this forum and I'll start with a simple Q. Should the MPAV power up when only power is connected? ( without Masterlink connected, only for testing main functions )