Hi guys, I've spotted that actually I was wrong saying that: > If I activate TV and then DVD (in tuner mode, EXT1 selected) - I get both a picture and a sound from TV Sound disappears after 1 min. Any iders? Thanks to all, Alexander

Hi guys, I'm struggling to get a sound from my STB (Virgin-Samsung) on my DVD2 in tuner mode. Picture is OK. Both connected to BV6-26: STB to AV1, DVD to AV2. Both are registered in BV6 setup. My problem: if I activate STB (picture and sound are OK), and then DVD (in tuner mode, EXT1 selected) - I get a picture from STB but no sound. However: if

I've just realised (from Wanted Forum) that it is possible to use STB controller with MX4000. Does anyone know: - Is it a in-build or stand along module? - Is it possible to use STB controller with MX4002? Thank you all, Alexander

A8 Black needed since my wife left it in an airplane... My location is Edinburgh. Alexander

Hi guys, Does anyone know what is "G-LINK" connector on DVD2? Thanks a lot, Alexander

Sorry, of cause there is a way to stop a movie - to press 'Load' again. I meant there is no way to switch DVD2 of or to put it into stand by except of disconnecting from mains. Regards, Alexander

Thank you Kokomo! I've digged out in the earlier posts on this forum that DVD2 doesn't have inbuild IR receiver either. Also there is no controls except of 'Load'. Thus strictly speaking is is possible to connect it to TV and mains and insert a disk it DVD2 might start show a movie (if it's primary role is DVD, rather than HDR).

Thanks again for the advice. I've got my preowned DVD2 yesterday. Just a quick question: Does it work with non B&O TV? Thanks and best regards, Alexander

Hi B&O fans, Just a simple question: Is it possible to use DVD2 with non B&O TV set? Thanks a lot, Alexander

Hi B&O fans, Just got my pre-owned DVD2. Have 3 questions about connections and would be very grateful for any answers: 1) What ChannelPlus emitter is for and where should it be connected to? (I found it in DVD2 package). 2) What "G-LINK" connector on DVD2 is for? (Manual says "Not to be used in B&O setup".) 3) And quite