Untitled Page
ARCHIVED FORUM -- April 2007 to March 2012
READ ONLY FORUM
This is the first Archived Forum which was active between 17th April 2007 and
1st March February 2012
Search
Page 1 of 1 (10 items)
-
Usually the default can be set using the on screen menu. Did you try it? S.P.
-
Thank you for your quick reply! Any microphone that is recommended? Thank you again.
-
Hello everyone ! I recently bought a used Century in very good condition. Works fine but I have two questions. I know I can record on the tape from radio or from the CD. Is there any way to record on the tape a conversation or from an outside source in general? Do you need a microphone? ( Where do I connect one? ). I do not see a build in microphone
-
Hello again ! Finally I got my 4500 to my local authorized B&O dealer. After all the required checks the problem was clear. You had guessed it. (Martin I think). The subplatter has been deformed. The problem was that during shipping the platter had been put under the hood wraped in a piece of paper and not under the beogram. Not a lot but enough
-
Thank you Martin. I agree with your point. I should be able to get the BG to an authorized B&O service center. Can the subplatter be fixed? or I will need to find another one? I will inform everyone of the outcome. Thank you again to all !!!! Spiros from sunny Athens.
-
Hello again, I tried to adjust the two out of the three (I did not remove the cover yet) screws but no luck. Same behaviour. The platter goes up and down. As a result I think, without being an expert, that the problem is that the subplatter has been deformed. I will try few more times and I might finally end up at the B&O service. The best would
-
Thank you Mika, It seems too risky for me so I have decided to take the BG 4500 to an authorized B&O service center to do it for me here in Athens Greece. Hope the sub platter is not warped and needs only adjusting the leaf springs. Thank you all so much for the valuable advise. I will keep you informed. Take care! Spirtos.
-
Hello again, I just realized that I cannot adjust all three leaf springs? How do I remove the cover in order to reach all three ? Thank you again ! Spiros.
-
Hello, thank you all for the quick responses. I checked again and the screws are fully open and hanging loose. As you mentioned the platter and arm are bouncing on the leaf springs but the platter is still catching. I will take the platter off and I will have a look at the leaf springs as you recommended. I hope the sub platter has not been deformed
-
Hello, I am a fan and I have read your valuable advice many times. This is my first question to all of you. I recently bought a used BG 4500. It arrived properly packed and all I did was I uptight the 3 screws at the bottom and connected it to my ouverture. When I put the first record I realized that the platter was not turning straight and as a result
Page 1 of 1 (10 items)