Hi Karsten - I used Maplin's Toslink converters ( http://www.maplin.co.uk/Module.aspx?ModuleNo=29293&criteria=toslink%20converter&doy=2m7 ) and they worked fine - not sure if these are suitable for where you are, if not I'm sure you be able to get something similar. I had noticed the BS3 picture was darker with my Panasonic and as I

Ok, one vote from the 6000 camp (looks like I'm in the wilderness compared to the 4000 support ) but I have my 6000's in line with the back of the sofa so they are about 100 degrees around from my seating position and much more involving than the wall mounted Mission 77DS they replaced. These are coupled with BL9 mains and BL7-4 centre, now

I agree, it would help consolidate experiences as I remember searching the old forum widely before purchasing my Beosystem. It may help having some stucture to it (FAQ?) otherwise it could end up being a massive thread which could become difficult to track.

The service engineer visited today and upgraded my Beosystem 3 to SW 3.1 - maybe this is in response to a fix for this problem. I'll update this thread with any future findings.

Yes, I had the same issue recently - see thread ( http://forum.beoworld.org/forums/thread/24069.aspx ). I was upgraded to 3.1 today and I'll post if any further problems occur.

Thanks Peter, glad to hear it not just with kikinoko screens. Interestingly I noticed after a bit more analysis at the weekend, the errors were only being logged when the system was being put into standby. It seemed they were being logged in the VMEM log every 2 minutes after power off and didn't appear to be added to the NVMEM log. There were TV

Confirmed with my dealer yesterday that you can buy the BV4 separately from BeoSystem 3. I guess the case in point is whether you would want to run one without a BeoSystem.

The dealer has spoken to technical and there is no obvious reason for the blinking LED, but possibly due to the connection to a non B&O screen. It seems strange that they would go to the trouble to make it blink without a good cause - maybe it's a subliminal message telling me to get a BV4! Anyway, I discussed the errors and will be put in touch

Seems normal to me too. I looked at slowing down the display time as you don't get to see the curtain opening effect with my PVR (unless it's already on) as you do with the integrated DVB-T. By the time the PVR gets the wakeup signal from the BS3 and it spins the hard disc the screen is up and the speakers active so I set it to the maximum for

Thanks Bang1. I traced the errors and there is only one which specifically states replace AVS board (APPLICATION_ERR - ERROR_CODE: 00F8 - PARAM: 00050051) and a couple of xx:xx:00:03 - for future use, so I'll raise this with my dealer tomorrow and see what transpires.