Hi Guys, I've just joined and am starting off with problems !!! - I have inherited a pair of Beolab 2500 speakers, but they are set for 120V and not for 240V supply - I've been doing a bit of reading on this forum and there are some posts which say that the transformer can deal with both inputs...

Hello, maybe someone of you have had the same error and can help me with a BeoLab Penta 2 is in constant of green light and will not go into standby , even if I try to shut it down manually are green lights left and does not extinguish , to turn off the Penta 2 that I have to unplug the power cord ....

Hi, I would like to use my balanced out from my Marantz AV7005 pre-amplifier to my beolab 5 speakers. Does anyone know whether this is possible and suggestions on how to connect? Thanks a lot for help. KR Herben

Hi I am looking into some beolab 5 speakers and would like to know what is the latest software version and where could I find a list stating serial numbers with construction year of the speakers? Thanks a lot for helping me out. Herben

After searching the forum I could not find an answer to what seems like a small and simple problem, so here it is: I changed my Beolab 7-1 for a 7-4 (because in surround setup I think it sound much better). Upon installing I noticed the power out socket on the back of my new 7-4 was covered with some...

Bonjour, This might be a simple question to some of you but, on a pair of Penta 3, I just had the midrange refoamed and now I have a doubt on the wiring. On the 4 midrange speakers, the 2 middle ones are cross-wired, but I did not mark the wires properly and now on one - is connected to -, and the other...

Hello, I have a BeoLab Penta 3 as one of the speakers when the bass setting on III so reduces the volume that is much stronger at setting II. The second BLPenta III goes as it should, on setting 3 reproduces the strongest sound but not the other reduces the noise instead of. Can someone give me me a...

My Avant has finally given up the the ghost and I have now replaced it with Samsung LED TV. I would like to connect my Beo Lab 6000's to them. Is this possible. I still have my Overture Hifi & Beo 4 remote. Any advice would be highly appreciated. Happy New year

Hi got a Beolab 8000 as has no Standby and complete death The Fuse F1 and F2 is ok also the thermal fuse is ok Fuse resistor R64 on PCB02 is ok So I guess the error is in stand-by transformer ????? I'm not sure and since I have to order a transformer I would like to sense if anyone else here had...

I have a Beocenter 9500 (purchased in Seattle in 1991) that was converted to 220v in Budapest (by the dealer there) about four years ago (I then moved to Rome and it continued to work fine). While in Budapest, I purchased a pair of Beolab 3 speakers that also worked fine in both cities. I am now back...