HiI have been given a beovision 3/32 today which has the following problem which I have just made a LOT worse. Initially it just dropped a green colour as it warmed up, when right the picture was great which i saw for about a 1/2 hr. i then removed the back and looked around it appeared not to dirty...

Hello anybody Any idears about this fault, i have recently installed a brang new origional B&O power supply pcb4 into my beovision 3/32 i am sure the connections are all made correctly but i still have a red glow and only that and considerably lighter on the pocket! is there any thing i am missing...

As it says, my Beovision 3-32 is suffering from visible blue flyback lines when showing a blank raster. Actual picture colorimetry is still good, so I guess it's just blue drive level. Can anyone tell me how to get into the service menu to adjust it? I'm an ex-tv engineer btw, so quite happy...

I have just purchased a known defective BV3/32 for its Surround module & STB/C but am also considering a repair if if won't cost more than the TV is actually worth When you press TV the standby light goes to green but there is no sound or picture and you have to remove power lead from the set...