The Beo5 & Beo6 Remote Forum

Re: New to config tool

f5434964 — Mon, 12 Dec 2011 03:42:08 GMT

Hi!

This should work - I've done this with commands through a XML-file; you are abble create soft keys and you programm the IR.codes to the hard keys as well! I have the same issue as you wrote - within the ConfigTool the new IR-commands are not shown but in "real life" it works fine!

regards elmar

Re: New to config tool

dariojbp — Sat, 10 Dec 2011 09:54:24 GMT

Can i program the buttons on the wheel stop play back stanby in equipment not bang?
After editing a button that will put the information is not recorded ctools 5
thanks
Sorryfor my English

Re: New to config tool

Tillquist — Sat, 10 Dec 2011 03:39:47 GMT

You Can make the file your self, it take a little time the first time but you well find it easy.

Here is a video demo http://beoforum.dk/viewtopic.php?f=52&t=338 and one more here http://beoforum.dk/viewtopic.php?f=52&t=339 -hope its help you :-)

Re: New to config tool

Oasis — Fri, 09 Dec 2011 17:59:12 GMT

Ok thanks for the advice.

I doubt the dealer will give me the file from their directory as they will want me to keep going back to pay for programming! Think I'll bite the bullet and configure it myself.

Re: New to config tool

kurfuer — Wed, 07 Dec 2011 08:18:22 GMT

You have to ask your dealer to get the directory of your Beo5 serial number from "...beo5configTool\Clients" program directory.

The Config tool creates a new directory inside "Clients" for every new Beo5 connected to the computer, this directory is named <serial number of new Beo5>. If you got this directory (and overwrite the local one created after connecting the Beo5), you can load your existing configuration and can change it.

There is no option to read the config from Beo5, it's one-way...

Re: New to config tool

Tillquist — Wed, 07 Dec 2011 06:34:04 GMT

Yes your have to start allover again.

You can not import the configuration from the beo5 to the computer, sorry.

New to config tool

Oasis — Wed, 07 Dec 2011 05:01:14 GMT

I have just started using the CT5.12.

My Beo5 was first programed by my dealer. However, I wanted to make some adjustments to it myself and when I load the program, I cannot access the existing program on the Beo5. Instead I have to commence everything from scratch. I am a bit hesitant as I have not configured the Beo5 before and if I start from scratch, it may not work properly...and I might have to go back to my dealer and pay lots of $$$!

Am I doing something wrong?