The Beo5 & Beo6 Remote Forum

Re: HexCode for LAMP command

Stefan_HH — Sun, 01 Feb 2009 12:31:27 GMT

Hi Mika,

thanks for Your input.

Is shows, that the LAMP command sends out the same IR code as the GOTO command.

And indead, using the GOTO command with Beo5 has the same result as the LAMP command on Beo4.

Thanks again

Stefan

tournedos — Fri, 30 Jan 2009 07:04:17 GMT

Lacking any of the appropriate equipment, I don't know the command semantics, but anyway:

pressing LIGHT on Beo4 sends 0x1b9b (17 bits)
pressing LIST until LAMP is displayed sends 0x1b58
pressing numbers in LAMP mode first sends 0x1b20, then 0x1b0? depending on the number (i.e two separate commands for each click)

Hope this makes at least some sense

Stefan_HH — Thu, 29 Jan 2009 16:47:14 GMT

Hi Jandyt,

that's curious!

Meanwhile I have version 1.10, 1.30 and 2.20 and all are missing the LAMP command.

What version are You using?

Cheers

Stefan

beo4me — Thu, 29 Jan 2009 03:41:46 GMT

Hi Jandyt,

I had a quick look in the command list and the only thing I could see is LIGHT:LIGHT. I could not see a LAMP command, where is it?

Cheers,
Frank

Jandyt — Wed, 28 Jan 2009 18:13:46 GMT

Hi Stefan, welcome to Beoworld.

Lamp amd Light are not missing from the config tool, I have the first firmware and software, and they are both in there.

Stefan_HH — Wed, 28 Jan 2009 16:29:42 GMT

Hi to All,

does anybody know the HexCode for the ‚LAMP’ (LIGHT:LAMP) command, which is unfortunately missing in the command list of the Beo5 config tool .

Knowing this HexCode and adding it to the file ‘IR Command table.xml’, I hope to enable this function on my Beo5.

Any suggestions/ideas?

Thanks in advance for Your help!