The Beo5 & Beo6 Remote Forum

Re: No response Samsung H360R

Doc — Mon, 23 Jun 2008 01:28:01 GMT

STB wasn't in the PUC-list anymore.

Now it's back in the PUC-list again: everything works just fine again!

Re: No response Samsung H360R

Keith Saunders — Sun, 15 Jun 2008 09:48:14 GMT

Doc,

Given that the STB template in the Configuration Tool has not been changed for 1.30, then I think we must assume that a fault has occured other than you re-creating your configuration with version 1.30 unless you have made a mistake using the Configuration Tool.

I would suggest the quickest way to prove the point is get a loan of a Beo4 and if the STB still does NOT work, then you have a fault NOT related to the Beo5 or version 1.30 software. On the other hand, if it does work we are sure there is something wrong with the configuration of your Beo5.

Re: No response Samsung H360R

Doc — Sat, 14 Jun 2008 02:39:22 GMT

Don't have a Beo4. But the sensor is allright....

Re: No response Samsung H360R

The Stig - ver. 1.7 — Fri, 13 Jun 2008 12:42:08 GMT

Dose it work with beo4 remote? cut just be the Ir transmitter thats fallen off...

Re: No response Samsung H360R

Doc — Fri, 13 Jun 2008 09:57:07 GMT

Yes, I did: in my case to AV3, and set it to DTV.

Re: No response Samsung H360R

Keith Saunders — Fri, 13 Jun 2008 09:49:45 GMT

When you dragged the STB from the list to the socket of the Beovision display in the product selection section of the tool, did you move it to the correct socket ?

Re: No response Samsung H360R

Doc — Fri, 13 Jun 2008 07:47:29 GMT

Made a hole new configuration with versio 1.30 Was that good or bad?

Re: No response Samsung H360R

Keith Saunders — Fri, 13 Jun 2008 05:54:01 GMT

I have just checked the details of the Samsung H360R template and it was added on 15th December 2007 in a previous update.

When version 1.30 was released, the same template version as previously available was supplied, therefore your problem does not relate to the template itself assuming it previously worked.

Did you re-create you configuration from scratch using version 1.30 or modify the existing configuration ?

No response Samsung H360R

Doc — Fri, 13 Jun 2008 03:31:43 GMT

I have been changing my beo5-setup with the new 1.30-software.

But now DTV (via Samsung H360R- receiver) isn't responding to the beo5 anymore... Not to the screen, nor to the hard buttons. The signals do work when switching to TV.

Anyone recognize the problem / has a solution?