The Workbench

Re: BeoMaster 1600 (Type 2113) wiring problem

yachadm — Thu, 03 Feb 2011 02:00:10 GMT

Martin

Thank you!

That is the correct connection. All Preset voltages normal now!

Menahem

Re: BeoMaster 1600 (Type 2113) wiring problem

Dillen — Wed, 02 Feb 2011 15:32:28 GMT

I seem to remember there are two slightly different
versions of the Beomaster 1600 chassis.
However, in the one shown here, that shielded lead goes to a
tag on the potentiometer, it may be the same in your BM:

Martin

BeoMaster 1600 (Type 2113) wiring problem

yachadm — Wed, 02 Feb 2011 12:07:59 GMT

Hi all,

Those of you with a BeoMaster 1600 could really help me!

In the attached pic, is a gray wire with a red stripe. It is a co-axial wire. It's under the Tuning capacitor.

The internal conductor was not connected anywhere, and the external sheath is grounded. It's other end becomes a yellow wire (gelb in the Service Manual), and goes to the 4 FM preset buttons.

Anyway, I connected it to where I thought it should be, as there was a big glob of solder, but it's not the correct place - the preset voltages are all over the place.

The SM I have, does not show a coax wire connected in this area, so if anyone with one of these could have a look inside his unit, and photograph the correct place to connect the internal conductor, it would really help me.

Thanks

Menahem