BeoWorld Private Wanted

Re: Beolab 6000 Bass Drivers x4

stotty1111 — Mon, 21 Mar 2011 08:22:29 GMT

yes, near centre with the point to the edge then gently lever/ease up - sort of nothing to lose, lots to gain!

Re: Beolab 6000 Bass Drivers x4

jkhamler — Mon, 21 Mar 2011 08:01:24 GMT

I did try with a vacuum cleaner alone to no avail, and with a bit of double sided tape which just seemed to pull the fibres from the dust cover.

So are you suggesting I make a tiny perforation in the dust cover with a sewing needle and pull out?

Re: Beolab 6000 Bass Drivers x4

stotty1111 — Mon, 21 Mar 2011 05:58:51 GMT

Agree with Prem.... that would have been my suggestion , tied in with GENTLE lifting using a fine sewing needle - used this technique with penta dust covers very successfully

Gice it a go - nothing to lose!!

tony

Re: Beolab 6000 Bass Drivers x4

Premiumverum — Mon, 21 Mar 2011 04:40:49 GMT

If it's just the dustcaps being pushed in you could try putting the brush on your vacuum cleaner and with increasing suction trying to get the dustcap to pop back in its original shape! Usually works very well, seems a bit overkill to replace the drivers just for this

Re: Beolab 6000 Bass Drivers x4

jkhamler — Mon, 21 Mar 2011 04:20:50 GMT

Hi Tony,

Ideally I'm looking for replacement drivers. I think replacing the dust covers will be a little beyond my technical ability!

Regards, Jon

Re: Beolab 6000 Bass Drivers x4

stotty1111 — Mon, 21 Mar 2011 03:51:04 GMT

What are you looking for? drivers or judt dust caps?

Tony

Re: Beolab 6000 Bass Drivers x4

Leslie — Sun, 20 Mar 2011 20:03:06 GMT

Have 4 (refoamed), somewhere

Beolab 6000 Bass Drivers x4

jkhamler — Sun, 20 Mar 2011 18:50:30 GMT

Unfortunately the centres of the bass drivers have been pushed in which doesn't seem to affect the sound at all but I'd like to get them sorted. A long shot perhaps but does anybody have any of these going spare?

Thanks, Jon