General Forum

Re: motorstand MX5500

EOB — Thu, 10 May 2007 17:41:33 GMT

for referene purposes;

I have put the fastening inside the din which might be touching the outershield of the cable wire a bit further so it was unlikely that it would touh.....

the other 3 conections in the din are now a little cramped but hey when tried ,.....it works !

Of course i would like to know if it is due to the shield part or maybe a wire breah that somehow now is fixed ,....but in the end ...it can be used

Thx for replies and help

Re: motorstand MX5500

EOB — Tue, 08 May 2007 10:13:33 GMT

took the din a bit further apart:

4 pins 3 are conected 1 seems to be never coneted.

but maybe this might be the cause ; th outer shield of the din has barely to no contact with shield around the cable.........isn`t it suposed to be the earth shield so conected to the din metal outer part ?

Re: motorstand MX5500

Christian — Fri, 04 May 2007 13:59:31 GMT

I think all four wires need to be connected for the motor stand to work. It might solve the problem, can anyone confirm??

Re: motorstand MX5500

EOB — Fri, 04 May 2007 10:57:36 GMT

Tried the wigle part ;)......I took the plug out and i am not sure ....is the green wire suposed to be not conected to a pin ? only 3 wires are conected.......

Re: motorstand MX5500

Kevin — Fri, 04 May 2007 10:37:14 GMT

That's experience that is...... won't learn that at college

Re: motorstand MX5500

Craig — Fri, 04 May 2007 09:59:36 GMT

nobby:
try wiggling the stand wire

Is that the technical term for it then mate.

Craig

Re: motorstand MX5500

nobby — Fri, 04 May 2007 07:24:27 GMT

Unlikely to be due to weight/balance ... try wiggling the stand wire ...

motorstand MX5500

EOB — Thu, 03 May 2007 16:58:00 GMT

Somehow it seems that the stand falls into a standstill .....if i push it a little it will continue.....is this due to wear inside the motor and can it be helped. Or might it be of influance that I mounted a MX3500 on it ? ( maybe not quite in balance as the MX5500 ?)...