General Forum

Re: Avant and MPAV 9000

bluemike — Fri, 29 Apr 2011 10:10:57 GMT

did you manage to hock up the mpav9000 to your avant?

if so how???

thx

Re: Avant and MPAV 9000

Craig — Thu, 28 Feb 2008 15:58:37 GMT

majand:
In the Avant manual there is a device connected to Avant, which looks like MPAV, but might be some other device. Is there a better option?

What you can see is the manual is probably a Beosound Ouverture. This is what the MPAV9000 is based on.

BEOSOUND OUVERTURE

Craig

Re: Avant and MPAV 9000

majand — Thu, 28 Feb 2008 15:43:00 GMT

Ulf, I'm a bit confused now, maybe, because I've never seen the MPAV in function.

So, would it be a good idea to buy the thing to go with Avant?

In the Avant manual there is a device connected to Avant, which looks like MPAV, but might be some other device. Is there a better option?

How about adding pair of Beolab 4000 into setup?

I have to admit, that I've dropped off a bit from B&O development. My experience and love to B&O dates to my trustworthy Beomaster 1900-2 and Beovision 601 era.

Pekka

Re: Avant and MPAV 9000

Ulf — Thu, 28 Feb 2008 05:14:34 GMT

No,

Beo4 works but no Buttons and no Display at the MPAV
Sound for all Sources RADIO,CD and TAPE works.

Ulf

Re: Avant and MPAV 9000

majand — Thu, 28 Feb 2008 04:59:07 GMT

OK, so Beo4 won't work?

But can I use the MPAV9000 directly, from buttons and get the sound out from Avant?

Pekka

Re: Avant and MPAV 9000

Ulf — Wed, 27 Feb 2008 12:42:38 GMT

Sorry for not.

it works, but no Display and settings....

Only LOAD and LIGHT give a response.

Ulf

Re: Avant and MPAV 9000

nobby — Wed, 27 Feb 2008 11:18:23 GMT

You are correct mobe.

Re: Avant and MPAV 9000

mobeyone — Wed, 27 Feb 2008 09:12:24 GMT

I think the short answer is no, the software or drivers required to operate the MP are built into the AV9000.

Someone will confirm for sure.

Avant and MPAV 9000

majand — Wed, 27 Feb 2008 09:09:52 GMT

Hi,

another question about my new Avant.

I might be able to obtain a MPAV 9000, or Master Panel AV9000. If my Avant had a surround unit attached to it, is it possible to connect that MPAV 9000 to my Avant? If so, do I need a Master Link cable or something which goes to some input sockets near Power Link sockets?

And if the above is OK, can I control the whole set with Beo4, or do I need the Beolink 5000?

(I'm not near the Avant now, so can't check the sockets)

Thanks again,

Pekka