General Forum

Re: bs-9000 pin protection

koning — Sat, 08 Dec 2007 09:21:17 GMT

Processor and sw eeprom are replaced.

Everything o.k now.

Thanks fred b

Re: bs-9000 pin protection

Roger — Sun, 11 Nov 2007 13:58:01 GMT

You may have a dead lock - I would recommend you to bring it to your dealer for a hard reset, that should solve your issue. If not, your dealer can do a read-out of the error code(s) and check them against the service manual.

Roger

Re: bs-9000 pin protection

koning — Sun, 11 Nov 2007 12:24:29 GMT

i didn't have the master code,only my own personel code.

Power as been off about an hour,when the power was on the beosound asked for the pincode.

Then I pulled the main power off.I did that 2 times

Now I can not activate my pin code because the buttons don't work anymore

Re: bs-9000 pin protection

Keith Saunders — Sun, 11 Nov 2007 10:57:49 GMT

I am assuming that you have your pin code ? please confirm..

On this version of the Beosound 9000 the pin code can be de-activated, if it was previously de-activated, i.e. if you turned the power off for a while, on switching it on again, it did NOT ask for a pin code, but due to some problem it has been re-activated, then you will need the pin code to put it back to its previous state.

So, what happen just prior to the problem occuring ?

Re: bs-9000 pin protection

Peter — Sun, 11 Nov 2007 09:46:34 GMT

We do have the service manual for this model but I would suggest that it won't get you very far! I think this needs to be seen by the service department.

Re: bs-9000 pin protection

koning — Sun, 11 Nov 2007 08:19:00 GMT

Is there anyone who knows what this could be

Re: bs-9000 pin protection

koning — Sat, 10 Nov 2007 14:00:56 GMT

type 2571 markIII year 2001

Now after six hours the led goes two time on and off!

Re: bs-9000 pin protection

Keith Saunders — Sat, 10 Nov 2007 12:41:50 GMT

What version of Beosound 9000 do you have? if you do not know, then how old is the unit ?

Re: bs-9000 pin protection

koning — Sat, 10 Nov 2007 12:02:25 GMT

everything is removed still the same problem.

How long will it normally take when the beosound is in pincode protection?

Re: bs-9000 pin protection

Keith Saunders — Sat, 10 Nov 2007 11:19:39 GMT

It is likely that a fault has occurred on your Beosound 9000, possible intermittent.

Switch the unit off and remove all connections, masterlink etc and then switch on again and see the results

bs-9000 pin protection

koning — Sat, 10 Nov 2007 10:57:32 GMT

when my bs-9000 asked for the pincode I stopped the power.

6 days later when I turned the power on nothing happend.

standbye led turned on,but cd or radio are not working

every 5 minutes you hear a click and the led turns off and on.

Is mine bs-9000 dead or is it the pin protection?