General Forum

Re: Beovision 5 connection to motorised stand

JY — Sat, 03 Nov 2007 06:44:43 GMT

Gerd, you are awesome. I have connected them up and it is fantastic. Thanks guys.

Re: Beovision 5 connection to motorised stand

The Stig - ver. 1.7 — Fri, 02 Nov 2007 15:59:47 GMT

Well thats explains why I can't find it PCB 3 is not easy to get to.

Re: Beovision 5 connection to motorised stand

Gerd — Fri, 02 Nov 2007 15:51:58 GMT

As far as I know PCB80 and 81 are inside the motor stand.

The cable should fit to socket P458 (see picture below - somewhere in the
blue circle) on PCB3 (red square).

Re: Beovision 5 connection to motorised stand

The Stig - ver. 1.7 — Fri, 02 Nov 2007 15:40:06 GMT

PCB 81 BUT I can't see where PCB 81 is placed on the chassis...

PCB 81 is connected to PCB80, and PCB 80 is connected to PCB 3.

Re: Beovision 5 connection to motorised stand

JY — Fri, 02 Nov 2007 06:58:42 GMT

Roger,

Thanks for your reply. However, as I mentioned above, I have opened up the speaker cover and still could not find the cable inside which is why I bought one. The problem is I can't find the socket where the cable should plug into the BV5.

Re: Beovision 5 connection to motorised stand

Roger — Fri, 02 Nov 2007 05:27:56 GMT

Facing the BeoVision 5, on the right hand side just above the stand socket on the motorized floor stand, you will find 3 cut-outs in the cabinet: Locate the socket on the stand, then just above it (bottom edge of the BV5) find the 3 cut-outs in the MDF-frame. The cable is tucked away and can be located/retrived using your fingers.

Roger

Beovision 5 connection to motorised stand

JY — Fri, 02 Nov 2007 03:44:32 GMT

guys,

I have just acquired a BV 5 and motorised stand. However, there is no cable to connect the two. I rang up the local store here in HK and have been able to buy the connecting cable. The problem is I can't seem to find the connection socket for the cable in the BV 5. I have opened up the speaker grill but can't seem to locate where the cable should go. Can anyone help?