General Forum

Re: BV 4 - 50 Panel Version with beosystem 3

jpb — Wed, 10 Oct 2007 03:24:15 GMT

Dear Gerd,

thanks a lot. I solved the issue without turning the auto detect off.

I changed the option within this menue for the display to 60hz on.
Than I only had to move the picture slightly to the left
now the clock is displayed correctly in all cases....

Thats why I love this forum!

Yours, JP

Re: BV 4 - 50 Panel Version with beosystem 3

Gerd — Tue, 09 Oct 2007 13:37:16 GMT

Should be a D7 panel (D8 starts at serial 19207548)

Enter "Customer Service Menu" by pressing MENU to access the TV SETUP menu,
place cursor on OPTION, then press RED and within 3 seconds GO.

Enter ADJUSTMENTS and check if WSS STATUS is on. If ok try MONITOR AUTO
DETECT off, quit service mode and enter TV SETUP > CONNECTIONS > DISPLAY.
You should be able now to set the resolution manually.

Remember that MONITOR AUTO DETECT should always be ON when a BV4 is
connected!

Good luck

Gerd

Re: BV 4 - 50 Panel Version with beosystem 3

jpb — Mon, 08 Oct 2007 11:09:00 GMT

Hi Frog,

thanks, but where do find this in the service menu?

Thanks JP

p.s.: Does anybody know which genereation this panel is?

Re: BV 4 - 50 Panel Version with beosystem 3

frog — Mon, 08 Oct 2007 05:00:12 GMT

You need to change the 'automatically detect what monitor' option in the service menu - then set uit up to use the correct resolution (it won't be grayed out any more)

Re: BV 4 - 50 Panel Version with beosystem 3

Beonut — Mon, 08 Oct 2007 04:56:51 GMT

Hello JP

You need to look in the service menu, to do this;

From standby using the beo4 remote press;

DTV

0 0 GO

Select Picture Adjustments

Select Screen Information

This will display the monitor type and screen resolution.

Cheers

Peter

BV 4 - 50 Panel Version with beosystem 3

jpb — Mon, 08 Oct 2007 03:00:37 GMT

Dear all,

I connected a BV 4 -50 to a new beosystem 3. Now I have some issues with resolution.
(i.e. the clock in the upper right corner is only shown half on the screen and with a camera
connected the picture is moved to the right, but than the clock is shown correctly!?)

Can anybody tell me what my panel with the series # 188 342 38 will be? A D7 or D8 Panel?

Moreover, where can I change the registration of the panel in the menue. Within connections
I can only change the projector, but not the panel? (the display 1: bv4-50 is shown in gray...)

Thanks for your help!