General Forum

Re: BeoCom 6000 no dial tone - no signal

valve1 — Wed, 05 Oct 2011 11:08:00 GMT

Beeme:
Unless the cable that is hard wired into the BeoCom 6000 base station is damaged

Thats where you should check first, try the bc4 there before packing all you kit off to get tested.

Re: BeoCom 6000 no dial tone - no signal

Beeme — Wed, 05 Oct 2011 06:03:37 GMT

I assume because my BeoCom 4 is working fine with a dial tone that there must be a problem with no dial tone "coming out of" the BeoCom 6000 base station. Unless the cable that is hard wired into the BeoCom 6000 base station is damaged. I suppose I just need to take it to B&O and ask them to look at it - Boring!

Re: BeoCom 6000 no dial tone - no signal

valve1 — Wed, 05 Oct 2011 02:24:11 GMT

Have you any way to prove you have dial tone going into the bc6000 base ? I see no reason the bc4 would not work as a hard wired extension from the base station socket.

BeoCom 6000 no dial tone - no signal

Beeme — Tue, 04 Oct 2011 10:50:22 GMT

Hi, I need advice on my BeoCom 6000 Mk1 which has stopped working. I have 3 handsets all still registered to the base station and although all still work for internal calls between handsets, I can't get a dial tone to make calls and can't receive calls. The handsets don't ring when there is an incoming call. I tried plugging the base station into another telephone socket but it didn't work, I briefly got a "no signal" message on the hanset screen. The handsets are still named and have phone book access. all handsets have a red flashing LED.

I also have a BeoCom 4 which works fine but i want the two systems working off the same telephone number, I don't need the two systems to intergrate, just all 4 phones working. The BeoCom 4 is plugged into the same socket as the as the internet router.

Any ideas about the BeoCom 6000 base station problem or advice would be greatly appreciated.

Michael.