General Forum

Re: Option Settings - Beolink Active and MC4002 in the same room

ajames — Tue, 13 Sep 2011 10:04:39 GMT

Actually, that's true, the cable won't take long but installing it will! - thanks for the suggestion - I will try that tonight

Andrew

Re: Option Settings - Beolink Active and MC4002 in the same room

Guy1680 — Tue, 13 Sep 2011 08:52:03 GMT

How about deleting all the MX4002 channels apart from the one that your RF link is set at? (or do I not understand the problem?)

Alternatively you could perhaps make your Beo4 a 'link only' remote (ensuring that the TV is set to a non-link option). If you do this the Beo4 should only work the Active;

Standby + List together

Press List till CONFIG appears

Enter 2002 , the display should read LINK ON

Press Exit

(Repeat to cancel)

There's probably a better way to do this and I am sure that others will come up with better ideas, but how long does it take to get hold of an ML cable?

Regards Guy

Option Settings - Beolink Active and MC4002 in the same room

ajames — Tue, 13 Sep 2011 06:59:44 GMT

Hi - I have both of these in the same room, once I purchase a longer Beolink cable I will move the active system into another and just have the beovision, but for the moment they are both together - which is a problem as I can get the TV picture through the link system and control through the Active, but the TV reacts as if it were standalone so pressing Sat means I get a picture but the TV changes channells whevere I scroll up or down.

Is there a V.Opt I can select for the TV to avoid this and have it act as a monitor only - I can always set it back again later when the ML Cable has been installed.