General Forum

Re: Where can I get a piece for my MX motor stand?

stotty1111 — Sat, 11 Jun 2011 02:12:09 GMT

Mark

Found both pieces - the plug is a little bent but should flatten with the stand weight on it - its quite pliable!

I'll pm you later today/tomorrow with more dtail etc

Salut

Re: Where can I get a piece for my MX motor stand?

deaddruid — Fri, 10 Jun 2011 14:45:01 GMT

The "plug" seems to be about 9cm diameter, whilst the channel seems to be about 20cm long.

Mark

Re: Where can I get a piece for my MX motor stand?

deaddruid — Sun, 05 Jun 2011 16:24:12 GMT

Ah! The posh end of town!

Sadly, I can't get to the TV until Wednesday, so I'll try to measure it then. It's not a whole circle, but has a slot cut into it.

Mark

Re: Where can I get a piece for my MX motor stand?

stotty1111 — Sun, 05 Jun 2011 01:55:32 GMT

Lived on Fruiitlands many years ago, at the side of the tunnel entrance -

have found some bits here in France, what diam is the plug you seek, also the length of the filler piece may be having a hairdresser nmoment but seem to remember different sizes etc!

salut

Re: Where can I get a piece for my MX motor stand?

deaddruid — Sat, 04 Jun 2011 16:45:15 GMT

Thank you, Tony. Seeing you list Worcestershire as one of your many locations, you must be (almost) a neighbour!

Mark

Re: Where can I get a piece for my MX motor stand?

stotty1111 — Sat, 04 Jun 2011 10:45:28 GMT

I might have both bits, recently picked up a tv with a stand etc - unfortunately its near Clows Top and i'm in France - i return uk in 2 weeks pm me for location etc if theyre there you're welcome!

I'll look here as well as I have some bits and pieces here i finistere

salut

tony

Where can I get a piece for my MX motor stand?

deaddruid — Sat, 04 Jun 2011 09:29:04 GMT

The motor stand for my MX4002 is missing a couple of pieces - the "plug" which goes in the bottom of the main upright support, and the cover for the wiring channel. The helpful guys at B&O in Bournemouth have tried to help me find a "plug", but without success. Can anyone here suggest where I might obtain either part?

I need the "plug" in order to spread the weight of the TV on a soft vinyl surface, as the sharp edges on the bottom of the upright could damage the vinyl.

I've tried to attach a picture, where the "plug" is part 9187 and the channel cover is part 9184. If I fail to attach the picture, I'll follow up with another email to provide it.

Basically - the channel cover is a "nice to have", but the plug is rather important!

Mark