General Forum

Re: BS3000 problem

ttshinykit — Sat, 30 Apr 2011 13:48:02 GMT

Thanks Opman, I'd checked that and just double checked and all buttons are fine.

Following the service manual, by pressing "sound 0258" I've gone into testmode and that booted up fine and I could read through all the TM codes but it goes into standby after 3 minutes. You're supposed to be able to key in <<11111 when prompted for pin and this should overide & give you 12 hours use for servicing before shutting down. It doesn't prompt for a pin number and this doesn't work by just keying it in. Arghhhhhh! :(

Re: BS3000 problem

Opman — Sat, 30 Apr 2011 08:55:46 GMT

Have a look to see if any of the rubber keys have been jammed under the edge of the panel. Maybe a corner or one edge is stuck.

Opman

Re: BS3000 problem

ttshinykit — Sat, 30 Apr 2011 08:29:54 GMT

Reading the service manual, if it was the pin that was required it would ask for it? I have never set a pin but it could be that trying to congigure it to the iphone i/r codes the gear4 unity remote has accidentally locked it up. I'll try the 5 digit service code when i get home and if that works i'll apply to B&O for a mastercode to unlock it which they apparently keep on their system in Denmark. Can anyone that uses a pin tell me if it does actually prompt you for the pin?

Seems strange that it powers up from the link room and then shuts down after a couple of minutes. Nothing works on the keypad apart from the load cd button. I really don't think it's a pin issue, any other ideas guys?

Re: BS3000 problem

ttshinykit — Thu, 28 Apr 2011 13:20:47 GMT

Nothing happens at all when I press cd. Does the BS3000 have a pin then?

Re: BS3000 problem

Seanie_230 — Wed, 27 Apr 2011 16:31:09 GMT

Sounds like it needs the pin number anything on the display when you press cd? Sounds like what used to happen to me when it needed the pin to be input

BS3000 problem

ttshinykit — Wed, 27 Apr 2011 16:01:22 GMT

Not sure what's happened but I have a bit of a problem. I have a red standby light on the BS3000 and doors open but no buttons are working apart from the load cd button. Beo4 has no effect on the system at all. When I check the option and press red button/list scroll to option/go scroll to A.OPT & press 1, I get a blink on the BS3000 but still nothing, speakers not powering up or anything.

If I go in the other room and turn on the masterlinked Beolab2000, I can play a cd from the BS3000 but only through the BL2000 and it turns itself off afte a few minutes.

I bought a gear 4 Unity I/R remote to use with my iphone and had it configured to the BS3000 last week but it's been playing up and i wonder if it's totally thrown the BS3000 I/R logic out. HELP!