General Forum

Re: Beosystem 2 -- link to a -- Panasonic TH-42PX700B can anyone help please ?

Brockely — Thu, 30 Aug 2007 04:26:55 GMT

Hi Ralf ,

I have now got the Beosystem 2 working , by entering the sub menu when it is connected to a B&O plasma.

The sub menu needs to be entered - when in the set up menu press ' 00' ' go' and check the plasma version setup -- plasma version PDP 42 D8 then using -- VGA-input set to VGA/Ypbpr and the DPD slot1 to the same setting ,

Connecting the CP251F to the BS2 setting the input to 576p 50HZ -- and the output at XGA 60 - seems to work fine .

Regs

Brockely

Re: Beosystem 2 -- link to a -- Panasonic TH-42PX700B can anyone help please ?

kallasr — Tue, 14 Aug 2007 05:01:03 GMT

Since I am thinking about a similar configuration: Did you solve the issues?

Does it work now?

Thanks!

Ralf

Re: Beosystem 2 -- link to a -- Panasonic TH-42PX700B can anyone help please ?

Brockely — Thu, 02 Aug 2007 10:53:25 GMT

Hi Frog ,

Can you give any advice please ? or anyone who has overcome this problem

I have purchased a Lektropacs CP255H scaler/conveter and I have had no joy with set up !

Using a 15 pin D plug -- RGBHV 575p 50HZ from the Beosystem 2 into the scaler using - 15 pin D plug and tried 3RCA composite

The Panasonic will see the Scaler (and the on screen menu) via the HDMI ouput an locks up at 60HZ 1080i - but no signal into the scaler from the B&O

Has anyone overcome this problem - apart from spending big money on a B&O 5 , nice as it my budget will not reach that far yet

Thanks Brockely

Re: Beosystem 2 -- operate with -- Panasonic TH-42PX700B

Brockely — Thu, 19 Jul 2007 11:40:38 GMT

Thanks very much Frog

I will try the box and report the results

Regards

Chris

Re: Beosystem 2 -- operate with -- Panasonic TH-42PX700B

frog — Tue, 17 Jul 2007 17:52:42 GMT

Just answered a similar question!

Yes, it sounds like you need the CP251F from Lektropacks for the frame rate change.

You can switch the panel using a Lintronic box and program it to take the serial output from the BS2 and turn it into a IR command to the screen

Beosystem 2 -- operate with -- Panasonic TH-42PX700B

Brockely — Tue, 17 Jul 2007 13:38:05 GMT

Can anyone help please ?

The setup between BS2 and a Panasonic TH42-PX700B plasma ??

When connected via the pc input it will not see the correct signal and the panel shows 60hz when connected - with no picture ??

I believe the BS2 is 50hz with 576p ?

would a scaler/converter do the trick ?

Is there also a way to add a rs232 to the Panasonic to switch the panel ?

Thanks

Regards Brockely