General Forum

Re: ML Grief

Vienna — Sat, 24 Apr 2010 05:34:01 GMT

benjnz:

Thanks for that I've come to the conclusion one of my junction boxes (the oldest one) was a bit munted, typical though - I nearly bought another one from B&O today but decided not too - sighs!

;-) ... j-boxes do not have a "second live" (and should preferably be replaced by j-boxes "large" with strain relieve)

Re: ML Grief

benjnz — Sat, 24 Apr 2010 04:18:20 GMT

Thanks for that I've come to the conclusion one of my junction boxes (the oldest one) was a bit munted, typical though - I nearly bought another one from B&O today but decided not too - sighs!

Re: ML Grief

Vienna — Sat, 24 Apr 2010 03:35:36 GMT

- check all ML plugs beeing plugged in firmly

As a first step you should set again the options of all units and check confirmation (LED "twinkling")

- all components have to be in standby

- BC 3200: set A.OPT to 0 / 1 / 2 (dependig on your main room(s) config w/wo speakers connected to BS3200)

- Avant: set V.OPT to 1 /2 (dependig on your main room(s) config w/wo speakers connected to BS3200)

- BLb3500: set L.Opt to 6

! Disconnect all components from power for minimum of 2 min !

Restore power and let the system autoconfig (don't use your remote for 1 min)

If this does not help you'll have to check the cables / junction box

ML Grief

benjnz — Sat, 24 Apr 2010 01:06:45 GMT

Help, I'm obviously doing something wrong. I've just moved around my Avant, BS3200 and BL3500. Just wall mounted the BL3500 and new cable to account for it, however I get everything back on and using the remote for a source on the BL3500 it turns on, shows the source and then goes back to standby. What deliberate thing have I missed in my wiring?