General Forum

Re: beoport and Ethernet?

kallasr — Fri, 16 Oct 2009 17:03:05 GMT

http://forum.beoworld.org/forums/t/9181.aspx?PageIndex=1

Read this (esp. Masterlink Handbook). I used to have this set-up. It work perfect!

Ralf

Re: beoport and Ethernet?

beoaus — Thu, 15 Oct 2009 00:59:15 GMT

Find the ethernet to masterlink cables here http://eu.bosscom.com/ . I think Lee also provides them. B&O used to sell them, not sure now.

good luck

beoaus.

Re: beoport and Ethernet?

elephant — Wed, 14 Oct 2009 20:20:43 GMT

Heribert:
near the BV8 and the BS3200

I use an Apple Airport (the small one) to get around this same problem; the minijack output of the airport is connected to my Beosound's AUX.IN

Elsewhere someone warned that the Airport minijack signal strength is too high for Beolabs, but I have not had that problem on my Beosound

Another alternative is wait for the rumour B&O support of cat 7 cables

Re: beoport and Ethernet?

joostdeclercq — Wed, 14 Oct 2009 15:43:08 GMT

There has been some threads on using UTP wire as masterlink wire. It is possible that these were on the old forum, which have been lost...

If I remember well, some of the wires in the masterlinkcable are not used. If you leave these out, you have enough wires in the UTP cable to do the job.

There are believers and nonbelievers for this. Some people have done it with good result, others encountered problems. One thing is sure and that's you need a shielded UTP (STP or FTP).

Kind regards and good luck

Joost

Re: beoport and Ethernet?

Hugoltrin — Wed, 14 Oct 2009 13:53:15 GMT

You say it................. "quite difficult"

PS a short cut ........ do the Masterlink wiring.

beoport and Ethernet?

Heribert — Wed, 14 Oct 2009 13:35:04 GMT

Hi,

I have the following setup, so far:

iMac which is linked to a routermodem which connects to my LAN. The LAN has a socket also near the BV8 and the BS3200.

Now I want to use a BEOPORT wo have my music from the MAC also on the BS3200. And since I already have an ethernet wiring I want to use this one instead of wiring a new Masterlink (quite difficult). I read something about ML to Ethernet conjunction but did not find a easy description and if I can buy.

Does anyone of you have an idea how the linking has to be connected? Which Equipment do I need?

Thanks a lot for your help,

Heribert