General Forum

Re: BeoCom 6000 - Speaker problem

Burnix — Tue, 30 Jun 2009 02:04:16 GMT

Dropping a 6000 usually results in the display showing funny stuff. This is because the connection between the display and the contact rubber is lost very briefly interferring witht the communication between the display and the main processor. When the display re-initialise (e.g. when pressing DOT 7 to enter the menu) the display returns to normal operation.

/Burnix

Re: BeoCom 6000 - Speaker problem

Jandyt — Mon, 29 Jun 2009 05:54:06 GMT

Excellent news!
Yesterday I managed to unclip a 6000 handset from my shorts while coming down a steel staircase from my patio,
It bounced on every step and when I picked it up, the display just read gobbledegook.
Two minutes later and it sprang back into life with just a few war wounds to show for its ordeal. Works fine now.

Andy T.

Re: BeoCom 6000 - Speaker problem

Arabica — Sun, 28 Jun 2009 09:58:12 GMT

SUCCESS!!!

I have replaced the speaker and it works great!

Thank you so much - for the speaker-part and all the help.
I only broke one of the top hinges - they were a bit tricky to get opened.

Thank you all again, so many times.

Re: BeoCom 6000 - Speaker problem

Keith Saunders — Thu, 25 Jun 2009 03:54:31 GMT

Good set of pictures Andy..

I am almost always up by 6am and at my PC by 7am to start work..

Re: BeoCom 6000 - Speaker problem

Jandyt — Thu, 25 Jun 2009 03:37:28 GMT

8
This was to show what the locking tabs look like.
Left click on any picture to see it bigger, then left click again to magnify.

Hope this helps you.

Andy T.

Re: BeoCom 6000 - Speaker problem

Jandyt — Thu, 25 Jun 2009 03:35:37 GMT

There! Coming apart nicely now, with no damage.

Re: BeoCom 6000 - Speaker problem

Jandyt — Thu, 25 Jun 2009 03:34:37 GMT

6
Once they're all in, it should tease apart starting from thw battery compartment.
Ignore my other hand, that is the remote for the camera.

Re: BeoCom 6000 - Speaker problem

Jandyt — Thu, 25 Jun 2009 03:33:36 GMT

And on the top. There are two locking tabs here, so I used a wide piece of card.

Re: BeoCom 6000 - Speaker problem

Jandyt — Thu, 25 Jun 2009 03:32:37 GMT

Same on the other side.

Re: BeoCom 6000 - Speaker problem

Jandyt — Thu, 25 Jun 2009 03:31:58 GMT

Roll it round and slide it up

Re: BeoCom 6000 - Speaker problem

Jandyt — Thu, 25 Jun 2009 03:30:57 GMT

Corner in first.

Re: BeoCom 6000 - Speaker problem

Jandyt — Thu, 25 Jun 2009 03:29:59 GMT

You're up early Keith, and beat me to it!
I just took some pictures to show the credit card method.
Nowhere near the quality of yours, but here goes.

Re: BeoCom 6000 - Speaker problem

Keith Saunders — Thu, 25 Jun 2009 01:27:32 GMT

To get the Beocom 6000 case open you will either need a tool as shown in the picture or a very thin bladed blunt tool to slip down the side.

After you have removed the two screws at the bottom of the battery compartment, carefully slip the tool both sides at the top of the battery compartment only allowing the back to move apart a couple of mm (milli-metres) The two clips at the top (shown, but not mark in red in the picture) will effectively act as the hinge for the back. Now slip your tool in at one of the top holding clips and it will start to come apart.

The the two sections come apart be careful with the top two holding clips which are effectively acting as a hinge as you remove the back as they can break off if to much force is used. As you remove the back, the wires for the speaker will need to be unplugged, its just a push fit.

Re: BeoCom 6000 - Speaker problem

Arabica — Wed, 24 Jun 2009 13:10:14 GMT

Hi Andy

The speaker come today - thank you so much.

But I am in trouble already, before I get the case opened.
I can pull out in each side and lift them, but the back is still stuck - should I slide it off or something else?

Thanks again.

Re: BeoCom 6000 - Speaker problem

Arabica — Fri, 19 Jun 2009 16:14:10 GMT

Hi Andy

Thank you so much - looking forward to recieving it.

I am not sure about the directions though.
I have never removed even the battery before, so could you explain it once more, even more detailed and slow?
Or is the any other guides/instructions on the web?

Thanks again.