General Forum

Re: Masterlink Size?

Gordon38 — Tue, 03 Feb 2009 16:28:27 GMT

I have 2 junction boxes in my installation and now I wish to spilt a masterlink cable in 3 - but I do not have the space for a juntionbox - Do I have to wire pink to blue/white (as on the picture above)? and how do I do this with 3 cables? or do I already have this short-curcuit from the 2 existing juntionboxes, so I dont need to think about it?

Re: Masterlink Size?

majand — Tue, 27 Jan 2009 08:55:52 GMT

How about bending, carefully, the connetor lengthwise to the cable and maybe use some tape to keep it that way. Then it should go through a smaller hole than the widht of the connector.

Pekka

Re: Masterlink Size?

Quim43 — Mon, 26 Jan 2009 16:26:34 GMT

dko7113:

Did you short-circuit the White/Blue and Pink and interconnect all ground terminals, which is automatically done in the junction box?

/Erik

I have this short-circuit in another part of my ML installation.

Re: Masterlink Size?

Nickyg63 — Mon, 26 Jan 2009 15:43:33 GMT

one thing I would like to add is when buying a masterlink junction box get a large as its very difficult to fit all the wires into a small!! Its a very straightforward job you get the tool with the box. Hope that helps

Nick

Re: Masterlink Size?

dko7113 — Mon, 26 Jan 2009 14:50:27 GMT

Did you short-circuit the White/Blue and Pink and interconnect all ground terminals, which is automatically done in the junction box?

/Erik

Re: Masterlink Size?

Quim43 — Mon, 26 Jan 2009 14:25:23 GMT

I did the job soldering the cables as it's showed in the image below.

Re: Masterlink Size?

bayerische — Mon, 26 Jan 2009 14:01:32 GMT

Craig:

Think I would stick with the junction box idea. It will require a much smaller hole. Masterlink plugs are 30mm at the widest point.

Craig

I was going to suggest the same thing.

Re: Masterlink Size?

dko7113 — Mon, 26 Jan 2009 13:15:11 GMT

So would I!

And it is not a hard job to connect the cable in the junction box, if you are not having 10 thumbs...

/Erik

Re: Masterlink Size?

Craig — Mon, 26 Jan 2009 13:04:59 GMT

Think I would stick with the junction box idea. It will require a much smaller hole. Masterlink plugs are 30mm at the widest point.

Craig

Re: Masterlink Size?

k984942 — Mon, 26 Jan 2009 10:33:23 GMT

How embarrassing! You're quite right! Just didn't think of that

Thanks

Re: Masterlink Size?

dko7113 — Mon, 26 Jan 2009 09:43:08 GMT

If you measure the masterlink socket on your Avants, you will have a pretty good idea of its size...

Masterlink Size?

k984942 — Mon, 26 Jan 2009 09:19:49 GMT

Hi All

I'm just about to masterlink two Avants and have decided that it may be easier to drill a hole through the wall and pass the masterlink and RF cable through. I did originally think of cutting the ML cable in two and using a junction box(to avoid having a hole big enough to get the ML plug through) but have now decided it might be easier to pass the ML cable with the ML end still on through the wall.

I haven't actually seen an ML plug in the flesh so can anyone let me know how big it is? I've borrowed a drill which I need to return before the ML cable arrives so I need to know how big a hole I need to drill.

Thanks