General Forum

Re: Beocenter 2 - cannot startup after flashing

Moller — Wed, 07 Jan 2009 19:02:08 GMT

Dear all,

Thanks for all the replies.

I have taken my BC2 down to my dealer, and he is currently looking at it - and is probably laughing at my stupidity.

Now I just look forward to receive it again.

Best regards,

Moller

Re: Beocenter 2 - cannot startup after flashing

Spiros — Sun, 04 Jan 2009 02:47:18 GMT

I would also suggest that you take it to the service.

I think that if it is a matter of re-flashing, should not take longer than a couple of hours (if not minutes) and you will take it back home happy!

Re: Beocenter 2 - cannot startup after flashing

jk1002 — Sat, 03 Jan 2009 21:21:41 GMT

How did you get the equipment and software to flash to begin with?

I would think you will have to bring it back to your dealer.

Cheers

Re: Beocenter 2 - cannot startup after flashing

Moller — Sat, 03 Jan 2009 14:25:43 GMT

Thanks for the replies, guys.

I'm starting to realise, that I have really messed with something that I am not qualified to. [:'(]

I've tried unplugging as suggested - no changes. The only thing that happens is that the LED flashes when I push one of the buttons.

With regards to the "programming umbilical" I suppose this refers to the cable between the socket box and the main unit. Alas, I didn't even know that I needed such a cable.

With regards to "retro-flashing" I don't really know how to try to reverse the situation. It would seem that I am stuck - and with myself to blame...

Any good ideas?

Moller

Re: Beocenter 2 - cannot startup after flashing

Russ — Sat, 03 Jan 2009 09:44:53 GMT

Try disconnecting the main unit from the socket box, and the socket box from mains power for a few minutes, then plug it all back up, an see how it does.

Did you replace the normal umbilical cable with the programming umbilical while you flashed it?

Re: Beocenter 2 - cannot startup after flashing

Spiros — Sat, 03 Jan 2009 09:30:15 GMT

Any chance that you could re-flash the old version ? (if you have it available)

Beocenter 2 - cannot startup after flashing

Moller — Sat, 03 Jan 2009 08:58:27 GMT

Dear Forum,

I have tried to flash update the software in my BC2. Something went terribly wrong i'm afraid. The BC wont start or respond to any buttons. The only thing I can do is to open and shut the DVD cover.

Is there a way to reset the system?

Thanks,

Moller