General Forum

Re: BeoCenter 2300 + BeoLab 2 + BeoLab 3

LarsJensen — Wed, 24 Sep 2008 12:00:33 GMT

As suggested I too think you should drop by a dealer and take a listen to the BL3 with and without the BL2 but personaly I think this combination makes perfect sence. They look perfect together and I think the BL3 needs a sub.

/Lars

Re: BeoCenter 2300 + BeoLab 2 + BeoLab 3

jk1002 — Wed, 24 Sep 2008 11:28:36 GMT

I had exactly your combination for a while. The BL2 makes much sense if you have a bigger room or listen to higher volume as it takes a bit of stress of the BL3.

I love mine, its hooked up to a BC2 / BV8 now.

Connection is no problem. You connect teh BL2 with one cable to BS2300 and then the BL3 to the BL2.

Re: BeoCenter 2300 + BeoLab 2 + BeoLab 3

kallasr — Wed, 24 Sep 2008 09:41:49 GMT

I say, you don't need the Beolab 2, but depends on your music taste.

Just take a few CDs to your dealer and listen to the Beolab 3s with and without a Beolab 2.

Ralf

Re: BeoCenter 2300 + BeoLab 2 + BeoLab 3

Ignace — Wed, 24 Sep 2008 09:25:45 GMT

Hi,

Yes, that it possible and yes, you are correct.

Powerlink runs from the Beocenter to Beolab 2, Powerlink from Beolab 2 to Beolab 3.

You can read about Powerlink and active speakers on the BeoWorld Main Site / Articles

Beolab active speakers

BeoCenter 2300 + BeoLab 2 + BeoLab 3

Nis — Wed, 24 Sep 2008 09:14:01 GMT

Hi there,

I have been offered a working BeoCenter 2300 for almost nothing. I'm new B&O's active speakers, has ontil now only being using the old BeoLab 5000, BeoMasters and passive speakers.

I'm wondering which speakers I should be using. My wife like the BeoLab 3, which I also can get second-hand to a resonable price. Would it make sence to use a BeoLab 2 together with the two BeoLab 3? Is that possible to make such configuration? Does that make sence?

How is the speakers connected? Dows the left+right signal run from the BeoCenter to BeoLab 2 and from here to the BeoLab 3? Will the BeoLab 2 remove the sub/low frequencies from the signal before sending it to BeoLab 3? Or does it work totally different?

Is there a guide available telling how all this modern stuff (PowerLink and active BeoLab speakers) works?

Regards Nis