General Forum

Re: Beolab 3000 display

philippebouquet — Thu, 22 May 2008 03:02:20 GMT

Just a question: did you place the source selector switch on video

(the same thing happened to me with a beovision avant until I found you must choose the type of source ( audio, video or off)

Philippe

Re: Beolab 3000 display

Peter — Wed, 16 May 2007 16:28:07 GMT

I am afraid that is software related. I don't think there is a fix as CDV was what DVD replaced and V-SAT describes DTV pretty well! You will also get A-TP2 instead of N.Music and PHONO instead of N.Radio!

Re: Beolab 3000 display

nofors — Wed, 16 May 2007 16:24:47 GMT

Thanks Graham. Now it works.

An awkward incident. I have own the speakers 15 wear or so, since the were new.

But i dont get the right "sign" on the BL3000. When i run the DVD it say CDV and the DTV says V-SAT, for example.

What do i do wrong now?

\|/ Peter

Re: Beolab 3000 display

joeyboygolf — Wed, 16 May 2007 06:58:42 GMT

nofors:

What side? On the Beolab 3000 or the BV 7?
\|/ Peter

On the side of each speaker is a slider switch labelled "Audio" "Video" "StBy"

Re: Beolab 3000 display

nofors — Wed, 16 May 2007 06:51:40 GMT

What side? On the Beolab 3000 or the BV 7?

\|/ Peter

Re: Beolab 3000 display

Jandyt — Wed, 16 May 2007 05:10:19 GMT

Sometimes the simplest answers are the best! Like--"Have you plugged it in?"
I once towed a Ford Corsair about 18 miles trying to bump start it then realised I still had the rotor arm in my pocket!

Andy T.

Re: Beolab 3000 display

PhilLondon — Tue, 15 May 2007 11:26:27 GMT

I have done now. It works. Thanks.

Re: Beolab 3000 display

Peter — Tue, 15 May 2007 10:39:38 GMT

Did you change the switch on the side from Audio to Video?

Beolab 3000 display

PhilLondon — Tue, 15 May 2007 09:54:35 GMT

Hi,

I have recently purchased a pair of Beolab 3000 speakers.

Using a fully cabled PowerLink cable I get no display when I connect them on a BV7 (as front or rear speaker), but I do get sound.

However, using the same cable I get the display working when connected on a BeoCenter 2500. So the problem is not from the speakers.

Should I get a display when connected on newer equipment?

Ph.