General Forum

Re: Masterlink connection = option???

kijf001 — Sat, 12 May 2007 01:37:15 GMT

Thanks for your help. I will contact the dealer what to do.

cheers

Re: Masterlink connection = option???

meandmyshadow — Fri, 11 May 2007 06:47:46 GMT

kijf001:
are you sure? because of the connection on the backsite? if you are, is it difficult to install a ml module?

Yes I'm sure, Beovision 1 & early Beocenter 1's had the socket for ML but not always the board inside. As for the fitting, it's not too bad but you might want to get a quote from an engineer to do it, it doesn't take long if you know what you're doing.

Re: Masterlink connection = option???

kijf001 — Fri, 11 May 2007 06:14:58 GMT

are you sure? because of the connection on the backsite? if you are, is it difficult to install a ml module?

Re: Masterlink connection = option???

meandmyshadow — Fri, 11 May 2007 05:39:25 GMT

kijf001:
serial number = 8520

when v.opt is set to 1 or 2, standby light gives 1 blinck.

If it does not blink when you try 'V.OPT 6' then it does not have an ML module fitted.

Re: Masterlink connection = option???

kijf001 — Fri, 11 May 2007 05:26:15 GMT

serial number = 8520

when v.opt is set to 1 or 2, standby light gives 1 blinck.

Re: Masterlink connection = option???

meandmyshadow — Fri, 11 May 2007 03:17:24 GMT

On a Beocenter 1 it should be standard but an easy way to check is try to put it in 'option 6' if the red light blinks then it has an ML module fitted.

Re: Masterlink connection = option???

PhilLondon — Fri, 11 May 2007 03:15:53 GMT

Give us the type number, it is a 4 digit on the back.

Masterlink connection = option???

kijf001 — Fri, 11 May 2007 03:04:15 GMT

Goodmorning,

I own a beocenter 1. On the backsite is a masterlink connection. Does this mean that de ML module is available or could it just be the connection without de module?

cheers