in Search
Untitled Page

ARCHIVED FORUM -- April 2007 to March 2012
READ ONLY FORUM

This is the first Archived Forum which was active between 17th April 2007 and 1st March February 2012

 

Latest post 03-01-2010 9:33 AM by nitro2. 5 replies.
Page 1 of 1 (6 items)
Sort Posts: Previous Next
  • 02-13-2010 9:28 AM

    • nitro2
    • Top 500 Contributor
      Male
    • Joined on 10-08-2008
    • belgium
    • Posts 84
    • Bronze Member

    help needed with the reviving of a BM7000 external ir "sensor "

    Who can helkp me ??

     

    i got a master 7000 without the external ir-sensor connector .....................

     

    so cable found ( thanks gregg ) and shipped , sensor found ( thanks to ebay ) , but it is not working.

    i found all bm7000 connections and schematics concerning this modification , but cannot find a schematic of the "sensor " itself.

     

    Who can help me ??

    nitro2

     

  • 02-13-2010 10:52 AM In reply to

    • nitro2
    • Top 500 Contributor
      Male
    • Joined on 10-08-2008
    • belgium
    • Posts 84
    • Bronze Member

    Re: help needed with the reviving of a BM7000 external ir "sensor "

    Thanks for your help ,

    In fact i was looking for the schematics of the complete device .

    see picture .

     

    Is there someone who has the installation description for this "sensor"-kit ( 8087018 )

     

     

    nitro2

     

  • 02-13-2010 1:05 PM In reply to

    Re: help needed with the reviving of a BM7000 external ir "sensor "

    Looks the same as the sensor for the Beomaster 5500?

  • 02-13-2010 1:28 PM In reply to

    • nitro2
    • Top 500 Contributor
      Male
    • Joined on 10-08-2008
    • belgium
    • Posts 84
    • Bronze Member

    Re: help needed with the reviving of a BM7000 external ir "sensor "

     

    Most likely it is all the same sensor 5500 , 6500 and 7000 .

    The connection on the bm has been dropped on the 6500 and 7000 , but was available as an upgrade-kit for these units.

    i have put in the cable conn 98 on the processor pcb , and measured the 4 lines and do think there is smoething wrong .

    so now it is time to measure , ...................

    If someone has the schematics , that would be of great help.

     

     

    nitro2

     

     

    nitro2

  • 03-01-2010 9:33 AM In reply to

    • nitro2
    • Top 500 Contributor
      Male
    • Joined on 10-08-2008
    • belgium
    • Posts 84
    • Bronze Member

    Re: help needed with the reviving of a BM7000 external ir "sensor "

    Hi forum ,

    The sensor is working , with help of nick who handed over valuable information.

    the thing to keep in mind is , that the 8 volt supply to the external sensor has to be wired-in , CP1 has to be connected to 8 volt otherwise there is no supply going into the sensor.

    8 volt can be found on the display/front pcb pin 4 of connector P11 .

     

    sensor schematics are here ;

     

     

     

    nitro2

Page 1 of 1 (6 items)