Preben,

I am sorry to hear that your dealer was not able to help you..

The standard cable from the IR receiver as shown below uses five (5) of the seven (7) pins

The diagram shows the connections looking from the pins

Super, it is working perfekt.

Thanks

Hi Keith,

On this topic I have a cheeky question for you;

I would like to use my active kit as an audio switch to input sound from my B&O system into an audio matrix to integrate with another system.

The system can output B&O ir codes and if I tape an ir blaster on the ir eye of the active kit everything works great but it looks so amateur.

So the question is if I take off the ir emitter and disconnect the ir eye, what pins on the ir in to the active kit should I connect the two cables of the ir out from the other system.

The other system gives me 2 configuration options;

1. Turn off ir carrier signal

2.steady state signal at +5v

thanks in advance

StUrrock