Hello,

few weeks ago my HDR2 often interrupted records for no reason. My dealer had updated the software of the HDR2 but this did not solve the problem. Therefore the HDR2 was sent to Munich, where the harddisk was replaced. After that records didn´t interrupt any more.

But from that time I have a NEW problem:

If I program a timer record with my HD module, the HDR2 switches on the HD module at the programmed time, but does not set the right channel. The HDR2 records always the last channel of the HD module that was on before turned off the whole system. My dealer and the technicians in Munich have no idea, although they have already contacted B&O in Denmark.

I guess now it has something to do with the above mentioned software update of the HDR2! My dealer told me, that it´s not possible to downgrade the software. My HDR2 shows in the service menue (0-0-GO) the following:

 H8 Information:

It help, if you tell us what setup you have !

most likely it's a sw problem and maybe in tv-set after update hdr2

by Hd module did you mean built in b&o ? or is it a separate box

Hi tompa,

thank you for your reply.

In the meantime I have got the solution directly from B&O Denmark. The reason for my problem was NOT the HDR2, but the internal HD module of my BV 10-40:

During my HDR2 was for repair in Munich, my dealer had replaced the HD module because it was gone. After replacing everything worked fine again. So I guessed the problem with my HDR2 (not switching to the right channel) was caused by the HDR2. But it was the HD module: After replacing the module it was necessary to make a "RESET TO FACTORY SETTINGS" in the service menue of the BV10-40!

Now everything works fine when I make timer records and I am happy with the setup.

Regards

Räuber