I need some help with my Beosound 9000 which shut down by it self after 3 seconds.

If you start the stereo by AUX, CD or Radio it will start and after 3 seconds go back to standby mode without any info.

I have no clue about why this happens.

The stereo is connected to a pair of Beolab 3 and a masterlink active in a diffent room with Beolab 4000.

This problem happend, what I think after installation of a new electrical cubicle in my house.

Anyone who knows what to do?

Best Regards

Hank

Hi Hank, was the power supply cut to the house during this period? I ask as the BeoSound 9000 may be asking for the PIN code.

Regards,
Cal

I think it´s a MK2 edition and it doesn´t use PIN code. Yes the power was cut in the whole house for 6 hours.

I talked to B&O service today and they told me to disconnect all units and leave it for 2 hours and then start up the stereo again. I will test this later today.

After the reboot of the system it´s even worse.

Now the standby led goes on and off, when the standby led is off all the led´s over the CDs are on. it´s flashing all the time.

Anyone who knows what it could be?

Seems like the B&O service is the only way out.

Can there have been an electrical spike, which fried the innards of your Beosound?

Would have this checked when you service it, you might get it billed on your insurance then.

bayerische:

Can there have been an electrical spike, which fried the innards of your Beosound?

Sadly... I agree

Hope you get it resolved!